Zooz 700 Series Z-Wave Plus Long Range DC Motor Controller ZEN53 LR

SMART MOTORS

PRODUCT HIGHLIGHTS

Control DC motors and make your blinds, shades, and awnings smart

Create schedules for morning and evening routines

Automate your shades and awnings based on data from smart sensors, including brightness levels, temperature, and motion

Choose from shutter or venetian mode for your motorized blinds

Installs behind the existing wall switch or at the motor (6-32 VDC power only, momentary button switch required)

700 series Z-Wave chip: stronger mesh network and faster communication

SmartStart and S2 authenticated security for a truly protected smart home

Long Range: if your hub supports Z-Wave Long Range, you'll get incredible direct hub-to-device signal coverage

Pigtail wires included for hassle-free set-up

Built-in signal repeater: helps keep your network quick and reliable

5-year extended warranty when registered and lifetime tech support

Note

Z-Wave gateway controller required - sold separately.

SPECIFICATIONS

Z-Wave Frequency: 908.42 MHz (US)

Power: 6-32 VDC

Maximum Loads: 1.5 A (use with DC motors only)

Z-Wave Range: Up to 300 feet line of sight (or up to a mile with Long Range enabled)

Dimensions: 1.5 " tall, 1.4" wide, 0.7 " deep

Operating Temperature: 32-104° F (0-40° C)

Installation: Indoor use only

RESOURCES

Download the Manual for the Zooz 700 Series Z-Wave Plus Long Range DC Motor Controller ZEN53 LR (PDF)

Advanced Settings

Support Portal

WORKS WITH

Z-Box Hub (recommended for Zooz products)

Home Assistant (Z-Wave JS)

HomeSeer (with Z-Wave Plus plug-in )

Homey ( Zooz App for Homey)

Hubitat ( custom driver required )

SmartThings ( Edge driver required )

Note

If you don't see your Z-Wave controller on the list above, please contact us before you purchase this product.

INSTALLATION

Before installing, make sure the motor runs on DC power (6-32 V DC) and it does not exceed 1.5 A. Follow the wiring diagram carefully to ensure correct installation. Use with button momentary switches only, do NOT connect to dimmers or electronic switches.

If you are not comfortable identifying the wiring and following the instructions, please hire a licensed electrician.

How to include the DC Motor Controller to your smart home network? 1. Bring your Z-Wave gateway hub or controller as close to the switch as possible 2. Put your Z-Wave controller in inclusion/pairing mode 3. Click the Z-Wave button on the relay 3 times quickly to finalize the inclusion process 4. A new on/off switch should appear on your controller's device list